Search results

My 94 4.0/manual has been sitting in the garage for just shy of a year and a half after my transmission went bad. Finally got around to getting it all back together with a new transmission from Novak and using the LuK clutch replacement kit. While I had it apart, I also replaced the rear main...

Recently had the transmission out to do some work and am now putting together. I'm stuck on getting the shift rod/linkage hooked back up. The transmission and skid plate are already installed and I'm having a helluva time getting that rod through the rubber bushing. I've done it before but can't...

I'm in the middle of replacing the rear main seal and have a question. I replaced both halves, making sure they were seated well. After torqueing down the bearing cap to 80ft-lbs, I noticed the edges of the seal kind of look pinched up a bit? Is this correct or did I mess up along the way? Some...

Hey folks, I've had a set of goferit tie rod flip inserts sitting in my garage for awhile and have been thinking of going through with it. I've read that it helps with reducing bump steer. Before committing, thought I'd ask and see if anyone has done this and what your thoughts/experiences...

My YJ has never had a sway bar and there are times when I wish it did, especially on the freeway. In planning to re-install the stock sway bar/disconnects I looked underneath and found that the bolts where the sway bar would connect on the steering bracket were broken clean off. So I'm at a...

Ok so I'm just about done with the installing the fenders back on and putting the engine bay back in order. There are 3 open connections and I'm unsure of where they go. As luck would have it, my pictures don't show where they plug or if they were even plugged in before. The previous owner had...

Hey all, So I took my fenders off a several months ago to do some work on the YJ. Work caught up with me for awhile and now I am just re-installing them and can't figure out where these brackets go. I looked through the pictures I took during the removal and can't spot them. I've mostly gotten...

So awhile back I installed the OME lift with their shackles and everything seemed fine. I was giving the YJ a look over and it seems the rear shackle is impacting my rear bumper (LOD). You can see the dark spot on the the left where it hits. It doesn't feel too bad when I run my finger over...

Hey guys, I'm looking into getting fenders and sliders for the YJ. Right now it's on a 2.5" OME lift on 33" tires (35" might be in the cards but not till for awhile). I've done so much reading on the subject my eyes are going to fall out of my head. I've went around the horn on metal cloak...