Latest activity
-
Chris replied to the thread New to forum and Wranglers.Welcome to the forum! There's nothing like driving a Wrangler on a nice sunny day! -
Hi, i'm Jason from Massachusetts. This is my 1st YJ and first Jeep in many years- had a couple of Cherokee Laredos quite a while back...
-
Ddieselearl replied to the thread Maine BA10 pilot bearing.according to Summitt, clutch # 361675, has a bushing/pilot set up, the bearing that you have should fit inside the bushing that already...
-
machoheadgames replied to the thread Maine BA10 pilot bearing.Your original looks like a bushing, not a bearing. You sure your new bearing isn't the same OD as what looks to be the bushing in the... -
Ddieselearl replied to the thread Maine BA10 pilot bearing.how are you getting along, do you have a outcome yet?
-
Ddieselearl replied to the thread 1993 runs rough.I know this is minor, what plugs are you running, wranglers work there best on champion 412{RC12LYC}, when was your last tune-up?
-
Ddieselearl replied to the thread New to forum and Wranglers.welcome to forum.i hope you enjoy."Its looking good".
-
Gilaguy23 replied to the thread 1993 runs rough.Hard to say on the 8 volts at the pump. Biggest issue I find on Jeeps is bad wiring and bad grounds. -
CHi, i'm Jason from Massachusetts. This is my 1st YJ and first Jeep in many years- had a couple of Cherokee Laredos quite a while back...
-
-
Flyer58 replied to the thread Maine BA10 pilot bearing.I bought a transmission rebuild kit and one of the roller bearings was the wrong size. They sent a replacement but I too was not good... -
Flyer58 replied to the thread 1993 runs rough.Yes it's the computer but that's how the system works. If the engine is not running, the pump may run for a few seconds to prime the...
-
AAnotherMotorist replied to the thread 1993 runs rough.Interesting point about the ecm. That reminds me of another thing. The fuel pump doesnt run with the key on. If I hook the wires...
-
There are a few things you can check before jumping to the conclusion that the shifter cable has snapped. Check the Shifter Linkage...
-
rrjank replied to the thread 1988 YJ automatic not going into gear.Can I bounce off this post--it is close to home. I will not astart or turn over. Cabinn shifter is in free flow...slides with ease. I... -
-
Ddieselearl replied to the thread Maine BA10 pilot bearing.are you sure it the right clutch kit.? i would talk with the company where you purchased and explain. if not get a pilot bearing puller...
