Flyer58
YJ Enthusiast From Magnolia, Texas
Latest activity Postings Attachments Images About
-
-
Flyer58 reacted to DOWNS's post in the thread What did you do in the garage / driveway today? with
Like.
Not today but this week. -
Flyer58 reacted to DOWNS's post in the thread What did you do in the garage / driveway today? with Like.
Day before yesterday I swapped the rear springs on the YJ. Nearly 30 years of wear and unknown number of miles with an automatic locker...
-
Good luck with a 3" body lift. That thick boot being that high up the shift tower will wreak havock on the shift forks if nothing else...
-
Flyer58 replied to the thread What did you do in the garage / driveway today?.Has to move the YJ to make room in my shop for a Jeep Patriot. New front right wheel bearing hub assembly installed. Four hour job...
-
-
Flyer58 reacted to machoheadgames's post in the thread 1994 Hunter Green SE “Back to Stock” Thread with Like.
Yeah I’ve sheared a transfer case knob stud before. I think I had installed the jam nut too tight. I don’t really remember. But anyways...
-
Flyer58 replied to the thread 1994 Hunter Green SE “Back to Stock” Thread.I couldn't get the shift knob off and ended up twisting off the threaded top off the shift lever. I gave up trying the transfer knob.
-
Flyer58 replied to the thread Help with 4WD indicator light.My vacuum lines are in segments and held together by small rubber tubes. I ended up connecting them and then applied a coating of...
-
Flyer58 replied to the thread What did you do in the garage / driveway today?.Finally getting around to painting a pair of full size doors I bought a while back. They needed a little minor repairs and that's done...
-
-
Flyer58 reacted to DOWNS's post in the thread What did you do in the garage / driveway today? with Like.
Pulled the AX5 with a bad 5th gear for swapping with an AX5 out of a 01 TJ. Parts should be here tomorrow.
-
Well, it turned out to be a thin metal insert. Maybe it was part of the last bushing? In any case, problem solved!
-
Flyer58 replied to the thread Problem getting Crown body mount to fit.How does that opening compare with all the others? Is that a typical factory weld for the body mount bracket? Looks like some welder...
-
I used sandpaper and a little grindstone to clean up the hole, and measured with calipers. The hole diameter is about 1.5-2mm less than...
-
Flyer58 replied to the thread YJ ‘93 Beach Cruiser.Freshwater beach or salt water beach? best to dunk the entire YJ in a pool of lizard skin if it's salt.
-
Flyer58 replied to the thread Problem getting Crown body mount to fit.I don't know why but I find that funny and can hear Jeep when something doesn't fit saying "It's a design feature" lol
-
-
-
Loading…
-
Loading…
-
Loading…
-
Loading…
