machoheadgames
Certified YJ Researcher From Dallas, TX
Latest activity Postings Attachments Images About
-
-
My god -
machoheadgames replied to the thread Still overheating.I see now. I had seen clutch fan mentioned early on, but then only electric mentioned recently which led me to believe the clutch setup...
-
machoheadgames replied to the thread Still overheating.You really should go back to the mechanical fan. Aftermarket electric fans are typically garbage and don’t flow near the proper amount...
-
machoheadgames reacted to Flyer58's post in the thread Every time a fellow member has a problem with their YJ my YJ seems to do the same thing! with
Like.
When I had the pump out last week that short hose looked good. The vent hoses on top were a little brittle and one had disconnected... -
machoheadgames replied to the thread Every time a fellow member has a problem with their YJ my YJ seems to do the same thing!.Not sure about the smell, but something relatively common I've seen if you installed an aftermarket fuel pump + sending unit, is that...
-
machoheadgames replied to the thread Idle drops when I coast in neutral.Mine (4.0) has always done this as well. I've had lots of dash rattling low idle vibrations over the years and haven't figured out if I...
-
machoheadgames replied to the thread 3 bolts sheared off at engine.It’s not common, but it does happen. It’s usually from 1 or more of the bolts not being properly tight which then the remaining ones...
-
machoheadgames replied to the thread 1994 4.0 manual YJ not going into gear.My issue with not being able to get into gear has always been master/slave cylinder assembly went bad, but I’ve never had squealing...
-
machoheadgames replied to the thread How to retain 4WD light with passenger solid axle shaft upgrade.I would remove the switch and operate it by hand, watching the dash light to see if the light goes on and off that way. Then that tells...
-
machoheadgames reacted to Judy 87YJ's post in the thread How to retain 4WD light with passenger solid axle shaft upgrade with Like.
Got it working! Thanks. It’s the little things sometimes. I thought the TJ switch ball was not far enough out but it works fine.
-
machoheadgames replied to the thread How to retain 4WD light with passenger solid axle shaft upgrade.What brand switch did you use?
-
machoheadgames replied to the thread Questions for the AX5 gurus.I want to say that the design of the snap ring remained until the end of that trans in 2002, but I’m not 100% sure. I do know the snap...
-
machoheadgames replied to the thread YJ LED blinker issues.Just to confirm, you left the front turns and side markers incandescent? If so, did you change the flasher relay?
-
machoheadgames replied to the thread AX-15 compatibility questions.There is basically no difference between a 94-95 and a 97. The 97 comes with a curve in the shift tower base (the base of the shifter...
-
machoheadgames replied to the thread Factory height suspension kits?.They are the same length front and rear so you can move them around where you want, although the factory had specific springs for 4.0 or...
-
-
Loading…
-
Loading…
-
Loading…
-
Loading…