Flyer58
YJ Addict From Magnolia, Texas
- Messages
- 1,115
- Reaction score
- 488
Latest activity Postings Attachments Images About
-
-
Flyer58 replied to the thread Luk Clutch Kit Throw Out Bearings.I'm going on 5 years with an internal LUK bearing in my AX-5, no problem -
Flyer58 replied to the thread Decent air filter for the 4.0?.Read all the reviews. Too much dirt and dust goes through the K&N filter and the pressure drop isn't much different than a good pleated...
-
Flyer58 replied to the thread Recommendations on repairing this wiring plug.Yes corrosion will cause them to get hot. I've used a small cotton Q-tip with vinegar to clean them and dissolve the corrosion. While...
-
Flyer58 replied to the thread Oil blowing out of dipstick tube.Do you have a way to check your compression in each cylinder? You may have a surprising amount of blow-by gasses.
-
I've watched a dozen or so very entertaining videos from this guy's channel and just found he made one about the 4.0 liter. Good info...
-
Flyer58 replied to the thread Full throttle gives a rattle sound.My heater fan box linkage rattles at a very specific rpm and can be very annoying. I can't lean over while driving to find the exact...
-
I checked the cap and wires. Everything looks good. I advanced the timing by about 4 degrees and it all seems to be working again. Not...
-
Flyer58 replied to the thread Carter BBD Rebuild Issues.Take the plugs out and see check the color or if they're wet with fuel. Sounds like something got loose with the spark if it was...
-
Flyer58 replied to the thread Starter relay #2.Is the relay getting power when you turn the key? It could be the ignition switch half way down the steering column or one if the many...
-
The snap ring pops out because of too much load on 5th gear. This comes from large tires that put the transmission under extra stress...
-
Flyer58 replied to the thread Best option for stock exhaust system replacement.I bought the complete set of the Walker exhaust from Rock Auto and it fit together perfectly with all the bends in the right places...
-
-
Flyer58 replied to the thread BBD new carb setup.Contact the seller. If you take it apart you may stop any chance of a refund.
-
Flyer58 replied to the thread Engine keeps running after key removal.That's often a sign of carbon building up on the pistons. I've tried the SeaFoam treatment several times and it does clean out carbon...
-
Buddy just welded my driver side back on this weekend. Collapsed it on a rock and bent it back, broke soon after. Nonissues with...
-
Flyer58 replied to the thread YJ OEM Center Console Attachment.Best of luck. That's a low spot of the frame where water sits and metal rusts from the inside.
-
-
Loading…
-
Loading…
-
Loading…
-
Loading…
