steering

Hi all, brand new to the group. I just got a 1987 yj about 2 months ago. 4.2L with an auto. I’m fairly new to wrenching on vehicles but have done some light work here and there. My issue is that I’m replacing the power steering gear box and I’m at the point of putting the remanufactured one...

Hi guys, I’m replacing my lower steering column bearing. I have it slid about 1 inch up the column shaft but it is starting to telescope up into the cabin towards the steering wheel. I can push it in more and get the retainer to seat with the e clip. Could I try pulling down on the shaft with...

I have a 91 YJ and I am trying to stiffen up the steering a bit. It's not too bad at low speeds but my wife (her Jeep) is terrified above 50mph. The recommendation and only aftermarket steering stabilizer I found was the Terraflex #1513001. When I pulled off the OEM stabilizer I pulled both...

Hello all, I'm working on updating my steering on my 95 YJ. I am going to use a kit from RuffStuff. The kit is a one ton kit that uses GM one ton tie rod ends. The kit requires me to cut my own tubing that they send, and weld in the ends, which is all fine. If I decide to mount the tie rods...

I have a 1995 yj and the steering column where it comes through the dash is offset to one side of the plastic housing. It has been this way since I purchased it. It causes the lower shaft steering knuckle to be at an angle. Is this just a yj thing or can anything be done to straighten?