TRevs
YJ Enthusiast From San Antonio, TX
Latest activity Postings Attachments Images About
-
-
TRevs replied to the thread Blinker issue.Not too difficult really. The FSM available on this site walks you through removing the steering wheel from the column. There’s no... -
-
TRevs replied to the thread Help installing folding back seat.The nuts are welded to the tub, so you won’t have to buy any unless yours are corroded or lost. There are different kinds of rear...
-
TRevs replied to the thread '95 Sahara, 1st YJ.Plus the cheap Quadratec door handle webbing snapped, so I went with a stock-style replacement. Instead of omix or crown, I found a much...
-
-
-
TRevs replied to the thread '95 Sahara, 1st YJ.I decided to cut off the exterior handle bracket and shim a thin steel bar to add about 2mm of depth. Again, not pretty but I think it...
-
-
TRevs replied to the thread '95 Sahara, 1st YJ.Since little welding jobs are piling up on this Jeep, I decided to get a beginner welder. Found a used Lincoln on Craigslist and started...
-
-
TRevs replied to the thread Ignition key removal when engine running.Yes I think that is normal for many American cars of that vintage. The next step is that the key won’t be needed at all.
-
TRevs replied to the thread '95 Sahara, 1st YJ.Everything seems to fit well in the new tailgate, except the recess for the outer handle is too shallow, and makes the handle stick out...
-
TRevs replied to the thread Help reading check engine codes.Is that the turn key on-off three times method? I have done that on my LJ but didn’t know it worked on YJs. I thought I would have to...
-
TRevs replied to the thread '95 Sahara, 1st YJ.I’m going to test fit everything before I paint it because the basecoat I had mixed was very expensive and I don’t want to waste it...
-
TRevs replied to the thread '95 Sahara, 1st YJ.As discussed in another thread, I decided to replace my tailgate, which was damaged prior to my acquisition of the jeep. I got it from...
-
-
TRevs replied to the thread Defroster control unit cable hook up.IIRC, you can’t put the cables in the wrong place because each plastic anchor has a slightly different pattern of its tabs. The...
-
TRevs replied to the thread Heater removal.I tackled this last fall. See my build thread for some pictures starting at post #112. It’s not hard to remove the glove box and the...
-
TRevs replied to the thread 1994 Hunter Green SE “Back to Stock” Thread.I’d bet you still have air in the lines somewhere. Have the pedal person push vigorously, and your caliper person tap the caliper with a...
-
-
Loading…
-
Loading…
-
Loading…
-
Loading…
