TRevs
YJ Enthusiast 47 From San Antonio, TX
Latest activity Postings Attachments Images About
-
-
TRevs replied to the thread '95 Sahara, 1st YJ.I still haven’t figured out what to do with the two rusted/sheared biday mount bolts. Nine out of 11 isn’t bad right? To finish the... -
-
TRevs reacted to machoheadgames's post in the thread 1994 Hunter Green SE “Back to Stock” Thread with
Like.
Still plugging away at the carpet. I reached the stopping point last time when I got to the shifters. As most of you know, the inner... -
TRevs replied to the thread '95 Sahara, 1st YJ.I have a can of spray adhesive, but I’m going to wait and see if it needs it. I’ll probably do a bit of minor trimming later anyway...
-
TRevs replied to the thread '95 Sahara, 1st YJ.And here I was thinking i got a good deal. They’re $6-8 each online from Summit or Quadratec. Plus shipping.
-
TRevs replied to the thread 1988 half-door no lock latch mechanism.I’m not familiar with latches without locks; how is it different from the ones with locks?
-
TRevs replied to the thread '95 Sahara, 1st YJ.The rubber grommet bumper holding the license plate off the tub was worn out; the ACE hardware guy got enthused looking for a suitable...
-
-
TRevs replied to the thread '95 Sahara, 1st YJ.New Crown filler neck and filler vent hoses. The old ones were a pain to get off, and hard to get to because you can’t really drop the...
-
TRevs replied to the thread '95 Sahara, 1st YJ.New Crown grommets for the two rollover valves on the gas tank. I found it easiest to insert the grommet alone first, then push the...
-
-
TRevs replied to the thread '95 Sahara, 1st YJ.And new body mounts for that crossmember. The grade 8 bolts were $4.50 each at the local ACE.
-
-
TRevs replied to the thread '95 Sahara, 1st YJ.I did some rust remediation on the crossmember in front of the gas tank while the tank was out.
-
-
TRevs replied to the thread '95 Sahara, 1st YJ.I got the roll bar back in and trimmed the carpet to my satisfaction. Recommendations: sharp razor knife, and leather gloves.
-
-
TRevs replied to the thread Problem getting Crown body mount to fit.Well, it turned out to be a thin metal insert. Maybe it was part of the last bushing? In any case, problem solved!
-
-
TRevs replied to the thread Problem getting Crown body mount to fit.
-
-
TRevs replied to the thread Problem getting Crown body mount to fit.Done
-
TRevs replied to the thread Problem getting Crown body mount to fit.It has a small flange on the top of the crossmember; I’ll see if I can get a photo. If I do get it out, it won’t matter that the...
-
-
Loading…
-
Loading…
-
Loading…
-
Loading…
