Hello to jeep fans from around the globe, I'm located in Europe where my Jeep YJ has a different harness from the US version.
In europe (export models) the harness to the rear has 4 wires
- Reverse
- Turn
- Brake
- Driving light
on the US lights there are only 3 wires
- Reverse
- Driving
- Brake / Turn
I've tried simply linking the turn into the brake wire but when connected and turn -> turn OK, when braking -> brake OK. But when turning and braking -> brake wins (and not the turn signal). I knew it was not that simple
I did some diging around and find some posts from US to EU (aka trailer setup) conversion or kits but nothing that does the opposite.
the under dash is quite a mess so I hope someone can help me in the good direction who has done that conversion?
Thanks a lot,
Jeroen
In europe (export models) the harness to the rear has 4 wires
- Reverse
- Turn
- Brake
- Driving light
on the US lights there are only 3 wires
- Reverse
- Driving
- Brake / Turn
I've tried simply linking the turn into the brake wire but when connected and turn -> turn OK, when braking -> brake OK. But when turning and braking -> brake wins (and not the turn signal). I knew it was not that simple
I did some diging around and find some posts from US to EU (aka trailer setup) conversion or kits but nothing that does the opposite.
the under dash is quite a mess so I hope someone can help me in the good direction who has done that conversion?
Thanks a lot,
Jeroen