Search results

Not much done over the winter. How are you doing? My transfer case is from an S10. The front drive shaft uses a slip on rather than u-joints at the transfer case, not like the original jeep. What did you come up with and what about the rear shaft? Thanks, Jeepster.

That looks like what I need. Expensive little sucker! Thanks

For the transmission shifter, all that I have looked at that mount to the transmission show a mounting bracket that bolts also to the rear of the trans. They all appear to be for 2 wheel drive. How did you mount your Lokar to the trans? Jeepster

Thanks RandyN. I'm not a fan of cable shifters either. I like what you have by the pics. Did the shifter for the t-case have mechanical linkage that came out of the Suburban. I like that a lot. Do you happen to know the model of the Lokar shifter? Some are shown attaching to the trans rather...

I have a 2003 5.3 LS mated to a 4L60E transmission. that I purchased as a pullout. The transfer case is a NP 231 from a 1996 S10/Blazer that has a SYE installed. This combination is going into my 1990 YJ that was originally a 4.2 with automatic trans and NP 231. Does anyone have any suggestions...

I am putting a 5.3L LS into my 1990 YJ. I will be using Advance Adapters engine mounts. The trans is a 700R and NP231. The YJ as purchased has a 6 inch lift. My question is, should I install a slip yoke eliminator. Since I have to weld the motor mounts in place, location of the mount is crucial...