Search results

So I'm lost! 1992 YJ 2.5 No Oil Pressure at Idle and low at drive. Has new crankshaft, bearings, oil pump, pickup, sending sensor, K&N oil filter, spark plugs, cables, oil pan gasket, Mobile 1 10w30 High Mileage Full Synthetic and No leaks anywhere. Any Suggestions would be GREAT!!!!

So I made the mistake of having a local Jeep performance shop work on my YJ and what a disaster. Went in to check the transmission, and they found it was a small leak. Needless a lot of money and leaks later, I get it back and the oil pressure is non existent and it is struggling at idle...

Alright so I'm calling it luck because just a guy figuring it out for the first time with a jeep in my garage! I did not try without the TC drop bc I kept overthinking the video about pinion on rear shaft. I was fortunate that my 4WD link was one of the few none rust solid items and I was able...

I just installed 2.5" RC lift kit and a 1" RC transfer case drop. Now my Shifter is lower and rough to get into 2nd, 4th, and reverse, and my 4wd wont shift down. I have 1992 Jeep YJ, 2.5, all original until this. Can use any advise! Thanks,

YOU DA MAN!!!!! When running all new speaker wire, I dropped it over the top of the dash as it was leaning forward. When I pushed dash back in place, the wire was bending the 5 gauge cluster plug and grounding that one light. I have fixed and all is back to functioning. Thanks again, and if...

Light had never come on even when replaced gauge cluster a couple months ago. This only started when I peeled back the dash panel to replace the speakers and install radio. Please note all the wires for the radio were bundled together in tape rusted. I cut them back and cleaned them very well...

1992 Jeep YJ, 2.5, Manual here. Just installed stereo and new dash speakers. All was rusted in and wiring in dash just bundled and wrapped. I cleaned up all the wiring and secured off only utilizing the constant, switched and ground. I ran all new speaker wiring. After finishing the install, the...