Whats the trick to seperate the shifter?

Stoopid Jeep

Stoopid Jeep

YJ Enthusiast
Joined
Dec 25, 2021
Messages
343
Location
North Idaho
I got a new boot rubber boot for above the shifter lock cup thingy, but I'll be darned if I can figure out how to pop the upper shifter off the lower shifter. 4 little tabs holding a square shaft. Specialty tool?
...bigger hammer?
1000011346.jpg
 
Find a way to clamp the shifter base, in a vise or similar. Slip a crescent wrench under the black portion, hammer on the head of the wrench. It’ll come off. Don’t do what you’re doing with the screwdriver, that could screw up the pressure fit that keeps it together. Need that intact so it doesn’t come apart on you while driving down the road.

Take care when securing the base in the vise. If you aren’t careful, clamping down on it could booger up the slots that the locating pins ride in. So clamp on the smooth round part, and use some sort of cloth too.
 
  • Like
Reactions: Stoopid Jeep
machoheadgames said:
Find a way to clamp the shifter base, in a vise or similar. Slip a crescent wrench under the black portion, hammer on the head of the wrench. It’ll come off. Don’t do what you’re doing with the screwdriver, that could screw up the pressure fit that keeps it together. Need that intact so it doesn’t come apart on you while driving down the road.

Take care when securing the base in the vise. If you aren’t careful, clamping down on it could booger up the slots that the locating pins ride in. So clamp on the smooth round part, and use some sort of cloth too.
Click to expand...

Copy that!
Clamp in vise "just so"
Slide 13/16 wrench under it, and WHACK it a few wood tomes with a 2lb drillin' hammer.

THANKS FOR THE ASSIST!!!
 

Attachments

  • 1000011349.jpg
    1000011349.jpg
    964.6 KB · Views: 27
  • Like
Reactions: machoheadgames
machoheadgames said:
Boom, there ya go.
Click to expand...

There's also a rubber sleeve, called a shift lever isolator seal. It's inside the retaining clip that's holding this together. You might be able to save it. If not you'll need to get a new one. The sleeve makes it a tight slip-fit inside. Without the sleeve back in, it'll be a tad sloppy when back together.

You can find the isolator sleeve on Amazon for like $9
 
Last edited:
Superbird17 said:
There's also a rubber sleeve, called a shift lever isolator seal. It's inside the retaining clip that's holding this together. You might be able to save it. If not you'll need to get a new one. The sleeve makes it a tight slip-fit inside. Without the sleeve back in, it'll be a tad sloppy when back together.

You can find the isolator sleeve on Amazon for like $9
Click to expand...

That’s on the transfer case shifter. Transmission doesn’t have that, it’s just an interference fit.
 
  • Like
Reactions: Stoopid Jeep
Top Bottom