Recent content by wildphilhickup

Answer: 12 point 9mm socket. This is what is needed to remove the two bolts. So, I got one off. The other was messed up. So I drilled the head out with a 1/4" drill bit fairly deep. Then I drilled the 1/4" hole out to 5/16". I bought a set of Craftsman Easy Outs. Pounded one of those...

I believe that the two bolts at the top of the bellhousing are 9mm - 12 point. ???

In the process of replacing my passenger side 2 piece axle shaft with a one piece. After I got everything out, I saw the need to clean out many years of "GUNK". What worked for me was a "toilet cleaner" brush, and a 9" cloth nap paint roller. I modified the toilet brush to have a long...

Bellhousing is different between the 2.5 and 4.2. The question is will the Peugeot transmission mount to the bellhousing behind the 2.5?

The Peugeot BA-10 is considered an inferior transmission. It will be okay for your 2.5, but I just pulled mine last week. 1987 YJ Wrangler. I replaced it with an AX-15. The Peugeot has an internal slave cylinder. That means you will have to pull it back out if you ever need to replace the...

They are super tight I am afraid I will break or damage head of bolt.

Other than the seals at the differential, are there any good seals to use at the outer ends of the axle tube? I see some of those aftermarket ones, but looks to me like they might hold dirt, mud, water inside the axle as opposed to keeping it out.

1987 YJ Bellhousing Bolt Size? There are 2 small bolts at the top of the bellhousing. What size are they? 9mm? I can't get them out. What to do?