Recent content by Weasellee

Dash work makes me tired and thirsty

The new lines are staying in the YJ they worked out great and actually sit nice. I did find the line you speak of on Rockauto and ordered it up for the LJ. Thanks again

Unfortunately my cell phones camera is shattered but it’s fun to share. As far as the lines I’ve had good luck with these before but Honestly i spent all night last night looking for something “better” for my LJ. Ordered the Russell brand from Quadratec because they were in stock and $100 for...

All the same. I’m quite sure.

Surprised this thread doesn’t get more use. This pst weekend went through the front 30 axle of Luci’s ‘95 2.5. New seals, hub assemblies, u-joints, Crown Performance extended brake lines, Black Majic Pads and Rotors(no comparison) and new NAPA E-Coated calipers. Make sure you properly...

Currently running stock 4:10 with 2.5, 33’s and the AX5. Looking to get more bottom end out of it. Anyone with gear expertise?? Thanks Brian

It wasn’t glowing when i was bleeding because the key was off. 😁 Also wasn’t glowing when test driving. Hence the need for support.

This issue I solved with a phone call to Blaine at Black Magic Brakes. He sold me an inexpensive tool to install in the “proportioning valve “ where the dash brake light plugs in. This salved everything.

If anyone cares. I placed my orders. BMB pads and rotors for late model TJ. Through Summit I have Timken late model TJ unit bearings, replacement bearing bolts and new axle nuts. Have spicer U-joints and axle seals ready to go. The Yj front axle is about to get some refreshing. Thanks for...

Your knowledge and assistance is greatly appreciated. Thank you sir.

Let me get this straight. I’m replacing everything. Brakes, bearings and seals. Most my Jeeps are Tj. This is my daughter’s Yj. The only benefit is the longer studs? It seems the TJ bearing is more cost effective and then my Jeeps will all have interchangeable parts.

That seems proper. I came up with that number. Thought i could use my spare TJ bearings but it seems i would then need TJ rotors. 🤔

Want to replace front wheel bearing assemblies in stock Dana 30. Does anyone have the Timken part number? Thanks

Fronts bled fine. Rears with new hard lines on the axle and new wheel cylinders still won’t give good pressure. I ordered Crown braided line set and when it arrives I’ll replace the rear soft line and in turn will need to replace the hard line from proportioning valve to rear of the frame. I’m...

What a great write up. I really appreciate you my friend. This looks like an easy one. I have the tool you specify already. This will be my first “disconnect “ Dana 30 but it seems it won’t be soon. 🇺🇸👍🏼