Forums
New posts
Search forums
Image search
Shop
Amazon Store
T-Shirts
Stickers
Members
Current visitors
Supporting Member Upgrade
Sponsors
About
Log in
Register
Search
Search titles only
By:
Search titles only
By:
New posts
Search forums
Image search
Search
Search titles only
By:
Search titles only
By:
Menu
Install the app
Install
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Forums
Jeep Wrangler YJ
YJ General Discussion
YJ cranks but no start
Reply to thread
Message
<blockquote data-quote="rudymags" data-source="post: 438362" data-attributes="member: 20868"><p>My '95, 2.5L, has developed the crank, crank,carnk but no start issue. Happened when I would drive it for a while, then after turning off, I could not get it to start. This staRted about 6 months ago. At that time, I would wait til it cooled the engine & thermostat read 100 or less. Then it would start. This week, however it just does not start at all. </p><p>I checked gas pressure: 42#, replaced CPS (twice), replaced IAT sensor, replaced coolant temp. sensor, replaced CO2 sensor, replaced fuel filter, replaced air valve.</p><p>It has spark, the CEL & Brake light come on when I turn the key</p><p>I hear a 'click' from under the hood when I turn the key. ECM?</p><p>Cleaned throttle body & replaced sensor there.</p><p>Today I took off the distributor, looked good. Replaced this unit, wires, & plugs when I got the jeep.</p><p>On the distributor, today, when I pulled off the cap lid, cleaned it, & the base it seemed to have some oily film on it.</p><p> It did start for me after that. </p><p>I let it run for some time until it read 190 or so on temp gauge. I turned it off, waited a few minutes, and no start. Now, it's no start at all. Cranks; No Start.</p><p>I am mystified. Can you all offer some tips as to what I can do next? HELP!</p></blockquote><p></p>
[QUOTE="rudymags, post: 438362, member: 20868"] My '95, 2.5L, has developed the crank, crank,carnk but no start issue. Happened when I would drive it for a while, then after turning off, I could not get it to start. This staRted about 6 months ago. At that time, I would wait til it cooled the engine & thermostat read 100 or less. Then it would start. This week, however it just does not start at all. I checked gas pressure: 42#, replaced CPS (twice), replaced IAT sensor, replaced coolant temp. sensor, replaced CO2 sensor, replaced fuel filter, replaced air valve. It has spark, the CEL & Brake light come on when I turn the key I hear a 'click' from under the hood when I turn the key. ECM? Cleaned throttle body & replaced sensor there. Today I took off the distributor, looked good. Replaced this unit, wires, & plugs when I got the jeep. On the distributor, today, when I pulled off the cap lid, cleaned it, & the base it seemed to have some oily film on it. It did start for me after that. I let it run for some time until it read 190 or so on temp gauge. I turned it off, waited a few minutes, and no start. Now, it's no start at all. Cranks; No Start. I am mystified. Can you all offer some tips as to what I can do next? HELP! [/QUOTE]
Verification
Post reply
Forums
Jeep Wrangler YJ
YJ General Discussion
YJ cranks but no start
Top
Bottom