Forums
New posts
Search forums
Image search
Shop
Amazon Store
T-Shirts
Stickers
Members
Current visitors
Supporting Member Upgrade
Sponsors
About
Log in
Register
Search
Search titles only
By:
Search titles only
By:
New posts
Search forums
Image search
Search
Search titles only
By:
Search titles only
By:
Menu
Install the app
Install
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Forums
Jeep Wrangler YJ
YJ General Discussion
Why would I get code 24 twice?
Reply to thread
Message
<blockquote data-quote="wance" data-source="post: 426016" data-attributes="member: 18889"><p>I have a 1994 Wrangler with the 2.5. I have recently rebuilt the engine and got it running and actually let it run for 30 minutes the other day. I did have problems with the map sensor not letting it stay running. I was getting codes 13 & 14 so I go to test the sensor and it checked fine so I tried starting it and it fired right up and that’s when it ran for 30 min.</p><p></p><p>So the next day after work I wanted to start it up to let it run some more before I take for the first drive. Now I’m getting codes 24, 13, & 14. It will start up right away and the rpm surges or pulsates until it just kills itself. I tested the tps(24) and I’m getting .76 volts at idle and 3.8 at wot so that should be fine. I started it back up and it seemed to run a little better but still surging. I checked the codes after that and I got 12 24 24 14 13 55.</p><p></p><p>Why would I get 24 twice? Also I replaced these sensors before I rebuilt it.</p><p></p><p>Sorry for such a long post but just want to make sure I give enough info. Let me know if I left something out.</p><p></p><p>This is my first Jeep and first full rebuild on my own so I’m definitely learning as I go.</p><p></p><p>Thanks</p></blockquote><p></p>
[QUOTE="wance, post: 426016, member: 18889"] I have a 1994 Wrangler with the 2.5. I have recently rebuilt the engine and got it running and actually let it run for 30 minutes the other day. I did have problems with the map sensor not letting it stay running. I was getting codes 13 & 14 so I go to test the sensor and it checked fine so I tried starting it and it fired right up and that’s when it ran for 30 min. So the next day after work I wanted to start it up to let it run some more before I take for the first drive. Now I’m getting codes 24, 13, & 14. It will start up right away and the rpm surges or pulsates until it just kills itself. I tested the tps(24) and I’m getting .76 volts at idle and 3.8 at wot so that should be fine. I started it back up and it seemed to run a little better but still surging. I checked the codes after that and I got 12 24 24 14 13 55. Why would I get 24 twice? Also I replaced these sensors before I rebuilt it. Sorry for such a long post but just want to make sure I give enough info. Let me know if I left something out. This is my first Jeep and first full rebuild on my own so I’m definitely learning as I go. Thanks [/QUOTE]
Verification
Post reply
Forums
Jeep Wrangler YJ
YJ General Discussion
Why would I get code 24 twice?
Top
Bottom