Forums
New posts
Search forums
Image search
Shop
Amazon Store
T-Shirts
Stickers
Members
Current visitors
Supporting Member Upgrade
Sponsors
About
Log in
Register
Search
Search titles only
By:
Search titles only
By:
New posts
Search forums
Image search
Search
Search titles only
By:
Search titles only
By:
Menu
Install the app
Install
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Forums
Jeep Wrangler YJ
YJ General Discussion
Transfer Case Rear Seal Install
Reply to thread
Message
<blockquote data-quote="dodgerammit" data-source="post: 441027" data-attributes="member: 21375"><p>I did a quick search on Rockauto. That part number is listed as the FRONT output seal, which makes sense given the image above showing the pvc tool driving it into the front output location. It also specs the bore as being 2.447" which is just a tad over 62mm.</p><p></p><p>The seal they list for the REAR output is P/N 4370N (Timken). It specs the bore as being 2.376 which is just a tad over 60mm. </p><p></p><p>These were found using a 93 Wrangler for the vehicle selection.</p></blockquote><p></p>
[QUOTE="dodgerammit, post: 441027, member: 21375"] I did a quick search on Rockauto. That part number is listed as the FRONT output seal, which makes sense given the image above showing the pvc tool driving it into the front output location. It also specs the bore as being 2.447" which is just a tad over 62mm. The seal they list for the REAR output is P/N 4370N (Timken). It specs the bore as being 2.376 which is just a tad over 60mm. These were found using a 93 Wrangler for the vehicle selection. [/QUOTE]
Verification
Post reply
Forums
Jeep Wrangler YJ
YJ General Discussion
Transfer Case Rear Seal Install
Top
Bottom