Forums
New posts
Search forums
Image search
Shop
Amazon Store
T-Shirts
Stickers
Members
Current visitors
Supporting Member Upgrade
Sponsors
About
Log in
Register
Search
Search titles only
By:
Search titles only
By:
New posts
Search forums
Image search
Search
Search titles only
By:
Search titles only
By:
Menu
Install the app
Install
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Forums
Jeep Wrangler YJ
YJ General Discussion
Transfer case grinding when shifting into 4 low…
Reply to thread
Message
<blockquote data-quote="redbullet" data-source="post: 433886" data-attributes="member: 19555"><p>I have an automatic 1993 yj 2.5L with the 321j transfer case. I am following the owners manual procedure to shift into 4 low (2-4 mph with transmission in neutral) and recently started to get a wild grinding noise only when trying to shift the transfer case. Fluid has been changed and is full. I am going to start with trying to adjust the linkage. Any tips on adjusting the linkage and thoughts on other solutions are much appreciated.</p></blockquote><p></p>
[QUOTE="redbullet, post: 433886, member: 19555"] I have an automatic 1993 yj 2.5L with the 321j transfer case. I am following the owners manual procedure to shift into 4 low (2-4 mph with transmission in neutral) and recently started to get a wild grinding noise only when trying to shift the transfer case. Fluid has been changed and is full. I am going to start with trying to adjust the linkage. Any tips on adjusting the linkage and thoughts on other solutions are much appreciated. [/QUOTE]
Verification
Post reply
Forums
Jeep Wrangler YJ
YJ General Discussion
Transfer case grinding when shifting into 4 low…
Top
Bottom