Forums
New posts
Search forums
Image search
Shop
Amazon Store
T-Shirts
Stickers
Members
Current visitors
Supporting Member Upgrade
Sponsors
About
Log in
Register
Search
Search titles only
By:
Search titles only
By:
New posts
Search forums
Image search
Search
Search titles only
By:
Search titles only
By:
Menu
Install the app
Install
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Forums
Jeep Wrangler YJ
YJ General Discussion
Thinking about a YJ
Reply to thread
Message
<blockquote data-quote="BCNYOU" data-source="post: 441717" data-attributes="member: 21473"><p>Hrm... Just my opinion but my jeep has some obvious rust on the fenders front and rear of about a 3 inch spot here and there except the front driver that got hit at one point and rotted through. My point is I have some rust but with the 95 it is galvanized so not normally as bad as other years, I have checked my frame end to end and am lucky I have a decent one at this point. My last yj was about like but luckily it was in a few spots that were not right on the shackle like the one your looking at or I would never have bought it. I have a plasma cutter and a multiprocess welder and the rust on the body I will fix myself but, that is alot of frame rust and unless you are very good with a welder or can take the tub off to weld it up I would pass if I was you. Again, just my opinion.</p></blockquote><p></p>
[QUOTE="BCNYOU, post: 441717, member: 21473"] Hrm... Just my opinion but my jeep has some obvious rust on the fenders front and rear of about a 3 inch spot here and there except the front driver that got hit at one point and rotted through. My point is I have some rust but with the 95 it is galvanized so not normally as bad as other years, I have checked my frame end to end and am lucky I have a decent one at this point. My last yj was about like but luckily it was in a few spots that were not right on the shackle like the one your looking at or I would never have bought it. I have a plasma cutter and a multiprocess welder and the rust on the body I will fix myself but, that is alot of frame rust and unless you are very good with a welder or can take the tub off to weld it up I would pass if I was you. Again, just my opinion. [/QUOTE]
Verification
Post reply
Forums
Jeep Wrangler YJ
YJ General Discussion
Thinking about a YJ
Top
Bottom