Forums
New posts
Search forums
Image search
Shop
Amazon Store
T-Shirts
Stickers
Members
Current visitors
Supporting Member Upgrade
Sponsors
About
Log in
Register
Search
Search titles only
By:
Search titles only
By:
New posts
Search forums
Image search
Search
Search titles only
By:
Search titles only
By:
Menu
Install the app
Install
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Forums
Jeep Wrangler YJ
YJ General Discussion
Starter Issues
Reply to thread
Message
<blockquote data-quote="Gilaguy23" data-source="post: 440303" data-attributes="member: 19498"><p>Bad cables can be deceiving as well. They may look fine but internally they are corroded and can cause your problem. Unloaded both starters seem fine, turning over the engine, not the case. Make sure your grounds are good to the block, body and frame. Im not clear on your "9 amps" . A starter will typically pull in the 250amps+ range. Did your battery voltage drop to 9V and was that off the battery posts, not the cables somewhere?</p></blockquote><p></p>
[QUOTE="Gilaguy23, post: 440303, member: 19498"] Bad cables can be deceiving as well. They may look fine but internally they are corroded and can cause your problem. Unloaded both starters seem fine, turning over the engine, not the case. Make sure your grounds are good to the block, body and frame. Im not clear on your "9 amps" . A starter will typically pull in the 250amps+ range. Did your battery voltage drop to 9V and was that off the battery posts, not the cables somewhere? [/QUOTE]
Verification
Post reply
Forums
Jeep Wrangler YJ
YJ General Discussion
Starter Issues
Top
Bottom