Forums
New posts
Search forums
Image search
Shop
Amazon Store
T-Shirts
Stickers
Members
Current visitors
Supporting Member Upgrade
Sponsors
About
Log in
Register
Search
Search titles only
By:
Search titles only
By:
New posts
Search forums
Image search
Search
Search titles only
By:
Search titles only
By:
Menu
Install the app
Install
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Forums
Jeep Wrangler YJ
YJ General Discussion
Starter Issues
Reply to thread
Message
<blockquote data-quote="ThunderLocke" data-source="post: 440297" data-attributes="member: 21322"><p>It did come with that, and it says that after 5/94, then it shouldn't require a shim because it's the newer mitsubishi starters, not the older bosch starters, so your '92 would require it, by my '95 shouldnt. The diag sounds are dependent on it starting, which all I'm getting is the single click which usually means a dead starter, but pulling the starter off and bench testing it shows it working fine, which is where I'm getting stuck at. I can't see the teeth after I've gotten the starter slid into place so I can't tell if I'm lined up properly or not and I'm not sure what could be causing the 3v drop between solenoid and starter motor</p></blockquote><p></p>
[QUOTE="ThunderLocke, post: 440297, member: 21322"] It did come with that, and it says that after 5/94, then it shouldn't require a shim because it's the newer mitsubishi starters, not the older bosch starters, so your '92 would require it, by my '95 shouldnt. The diag sounds are dependent on it starting, which all I'm getting is the single click which usually means a dead starter, but pulling the starter off and bench testing it shows it working fine, which is where I'm getting stuck at. I can't see the teeth after I've gotten the starter slid into place so I can't tell if I'm lined up properly or not and I'm not sure what could be causing the 3v drop between solenoid and starter motor [/QUOTE]
Verification
Post reply
Forums
Jeep Wrangler YJ
YJ General Discussion
Starter Issues
Top
Bottom