Forums
New posts
Search forums
Image search
Shop
Amazon Store
T-Shirts
Stickers
Members
Current visitors
Supporting Member Upgrade
Sponsors
About
Log in
Register
Search
Search titles only
By:
Search titles only
By:
New posts
Search forums
Image search
Search
Search titles only
By:
Search titles only
By:
Menu
Install the app
Install
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Forums
Jeep Wrangler YJ
YJ General Discussion
Spring Lift and New Shocks Question
Reply to thread
Message
<blockquote data-quote="machoheadgames" data-source="post: 430811" data-attributes="member: 18789"><p>I just noticed you said you plan on doing the bushings, good. As I said in my previous post, absolutely no squeaks on my end in 8 years so I think they’re fine. I did have some squeaking from my RC springs themselves on bumps but eventually that went away on its own. I know it was the springs because I sprayed between all the leaves with WD40 and it stopped. Then it came back of course after all that dried up, but I left it and eventually I noticed no more squeaks. But the bushings have always been fine.</p><p></p><p>it’s important to grease them with white lithium grease upon install. After that I’ve never really done any regreasing, there is nowhere for it to go except to leak out and I haven’t had any problems with that, so mine have stayed nice and greased long term no problem. No noise as a result.</p></blockquote><p></p>
[QUOTE="machoheadgames, post: 430811, member: 18789"] I just noticed you said you plan on doing the bushings, good. As I said in my previous post, absolutely no squeaks on my end in 8 years so I think they’re fine. I did have some squeaking from my RC springs themselves on bumps but eventually that went away on its own. I know it was the springs because I sprayed between all the leaves with WD40 and it stopped. Then it came back of course after all that dried up, but I left it and eventually I noticed no more squeaks. But the bushings have always been fine. it’s important to grease them with white lithium grease upon install. After that I’ve never really done any regreasing, there is nowhere for it to go except to leak out and I haven’t had any problems with that, so mine have stayed nice and greased long term no problem. No noise as a result. [/QUOTE]
Verification
Post reply
Forums
Jeep Wrangler YJ
YJ General Discussion
Spring Lift and New Shocks Question
Top
Bottom