Forums
New posts
Search forums
Image search
Shop
Amazon Store
T-Shirts
Stickers
Members
Current visitors
Supporting Member Upgrade
Sponsors
About
Log in
Register
Search
Search titles only
By:
Search titles only
By:
New posts
Search forums
Image search
Search
Search titles only
By:
Search titles only
By:
Menu
Install the app
Install
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Forums
Jeep Wrangler YJ
YJ General Discussion
Neutral Safety Switch
Reply to thread
Message
<blockquote data-quote="AbileneYJNewbie" data-source="post: 434856" data-attributes="member: 20275"><p>Good afternoon. I'm fairly new and in the process or rewiring my original harnesses on my 87 YJ. I'm using a painless 25 circuit wiring harness on a 2.46L, 4cyl, TBI, 5 speed manual tranny. I'm not too sure about the NSS. The painless harness has two wires labeled ignition switch starter solenoid(start)(nss) and the other labeled (nss)starter solenoid (start). Looking at my trans, I can see two electrical connections. I'm thinking one is the reverse switch. The other I'm thinking is the reverse lights. My question is if anyone here has worked with the painless setup before and any suggestions. I'm assuming the NSS wires should both go to the starter solenoid on the firewall since they are both 12 gauge. But I would like some advice as I don't want to cause this beauty to go up like a cabin in a California wildfire lol.</p><p></p><p>[ATTACH=full]119898[/ATTACH]</p><p></p><p>[ATTACH=full]119899[/ATTACH]</p></blockquote><p></p>
[QUOTE="AbileneYJNewbie, post: 434856, member: 20275"] Good afternoon. I'm fairly new and in the process or rewiring my original harnesses on my 87 YJ. I'm using a painless 25 circuit wiring harness on a 2.46L, 4cyl, TBI, 5 speed manual tranny. I'm not too sure about the NSS. The painless harness has two wires labeled ignition switch starter solenoid(start)(nss) and the other labeled (nss)starter solenoid (start). Looking at my trans, I can see two electrical connections. I'm thinking one is the reverse switch. The other I'm thinking is the reverse lights. My question is if anyone here has worked with the painless setup before and any suggestions. I'm assuming the NSS wires should both go to the starter solenoid on the firewall since they are both 12 gauge. But I would like some advice as I don't want to cause this beauty to go up like a cabin in a California wildfire lol. [ATTACH=full]119898[/ATTACH] [ATTACH=full]119899[/ATTACH] [/QUOTE]
Verification
Post reply
Forums
Jeep Wrangler YJ
YJ General Discussion
Neutral Safety Switch
Top
Bottom