Good afternoon. I'm fairly new and in the process or rewiring my original harnesses on my 87 YJ. I'm using a painless 25 circuit wiring harness on a 2.46L, 4cyl, TBI, 5 speed manual tranny. I'm not too sure about the NSS. The painless harness has two wires labeled ignition switch starter solenoid(start)(nss) and the other labeled (nss)starter solenoid (start). Looking at my trans, I can see two electrical connections. I'm thinking one is the reverse switch. The other I'm thinking is the reverse lights. My question is if anyone here has worked with the painless setup before and any suggestions. I'm assuming the NSS wires should both go to the starter solenoid on the firewall since they are both 12 gauge. But I would like some advice as I don't want to cause this beauty to go up like a cabin in a California wildfire lol.