Forums
New posts
Search forums
Image search
Shop
Amazon Store
T-Shirts
Stickers
Members
Current visitors
Supporting Member Upgrade
Sponsors
About
Log in
Register
Search
Search titles only
By:
Search titles only
By:
New posts
Search forums
Image search
Search
Search titles only
By:
Search titles only
By:
Menu
Install the app
Install
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Forums
Jeep Wrangler YJ
YJ General Discussion
Jeep wrangler revs but won't go anywhere hardly
Reply to thread
Message
<blockquote data-quote="SirDoopYJ" data-source="post: 433018" data-attributes="member: 19139"><p>Another possible leak area will be the "Input shaft selector seal". It is located on the left side of the transmission where the shift linkage and neutral safety switch are. Read one source that states it is a common leak spot.</p><p></p><p>And to give you better names for the front and rear seal I mentioned earlier. The front seal is the "front pump seal" the rear seal is the "transfer case input shaft seal" I am still unsure how to inspect these, but you will have to remove the transmission to change the front seal. For the rear seal you just have to remove the transfer case out of the way. Hopefully, it is not the seals, as I am sure it will be a pain to change if DIY.</p></blockquote><p></p>
[QUOTE="SirDoopYJ, post: 433018, member: 19139"] Another possible leak area will be the "Input shaft selector seal". It is located on the left side of the transmission where the shift linkage and neutral safety switch are. Read one source that states it is a common leak spot. And to give you better names for the front and rear seal I mentioned earlier. The front seal is the "front pump seal" the rear seal is the "transfer case input shaft seal" I am still unsure how to inspect these, but you will have to remove the transmission to change the front seal. For the rear seal you just have to remove the transfer case out of the way. Hopefully, it is not the seals, as I am sure it will be a pain to change if DIY. [/QUOTE]
Verification
Post reply
Forums
Jeep Wrangler YJ
YJ General Discussion
Jeep wrangler revs but won't go anywhere hardly
Top
Bottom