Forums
New posts
Search forums
Image search
Shop
Amazon Store
T-Shirts
Stickers
Members
Current visitors
Supporting Member Upgrade
Sponsors
About
Log in
Register
Search
Search titles only
By:
Search titles only
By:
New posts
Search forums
Image search
Search
Search titles only
By:
Search titles only
By:
Menu
Install the app
Install
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Forums
Jeep Wrangler YJ
YJ General Discussion
Is the bleed line for the clutch slave cylinder supposed to have play?
Reply to thread
Message
<blockquote data-quote="Rob-J" data-source="post: 433785" data-attributes="member: 20119"><p>I seem to have a similar problem. I bled the clutch. It was working perfectly then just went dead. Peddle would go to the floor, no clutch. I have not lost any fluid. I'm going to bleed it again just to make sure there is no air in the system, and test it again.</p></blockquote><p></p>
[QUOTE="Rob-J, post: 433785, member: 20119"] I seem to have a similar problem. I bled the clutch. It was working perfectly then just went dead. Peddle would go to the floor, no clutch. I have not lost any fluid. I'm going to bleed it again just to make sure there is no air in the system, and test it again. [/QUOTE]
Verification
Post reply
Forums
Jeep Wrangler YJ
YJ General Discussion
Is the bleed line for the clutch slave cylinder supposed to have play?
Top
Bottom