Forums
New posts
Search forums
Image search
Shop
Amazon Store
T-Shirts
Stickers
Members
Current visitors
Supporting Member Upgrade
Sponsors
About
Log in
Register
Search
Search titles only
By:
Search titles only
By:
New posts
Search forums
Image search
Search
Search titles only
By:
Search titles only
By:
Menu
Install the app
Install
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Forums
Jeep Wrangler YJ
YJ General Discussion
How to wire LED pods for turn signals
Reply to thread
Message
<blockquote data-quote="machoheadgames" data-source="post: 432820" data-attributes="member: 18789"><p>The double wire is the parking lamp, the second wire is just a jumper that goes back into the harness and runs over to the right side light. Right side light should only have 3 wires. </p><p></p><p>You would need to:</p><p></p><p>-hook the new light’s ground to the black</p><p>-splice the two parking light wires in the Jeep together and then put a resistor and diode after the splice. Then put a diode on the turn signal wire. Then splice those two together and splice them to the second wire on the new light.</p></blockquote><p></p>
[QUOTE="machoheadgames, post: 432820, member: 18789"] The double wire is the parking lamp, the second wire is just a jumper that goes back into the harness and runs over to the right side light. Right side light should only have 3 wires. You would need to: -hook the new light’s ground to the black -splice the two parking light wires in the Jeep together and then put a resistor and diode after the splice. Then put a diode on the turn signal wire. Then splice those two together and splice them to the second wire on the new light. [/QUOTE]
Verification
Post reply
Forums
Jeep Wrangler YJ
YJ General Discussion
How to wire LED pods for turn signals
Top
Bottom