Forums
New posts
Search forums
Image search
Shop
Amazon Store
T-Shirts
Stickers
Members
Current visitors
Supporting Member Upgrade
Sponsors
About
Log in
Register
Search
Search titles only
By:
Search titles only
By:
New posts
Search forums
Image search
Search
Search titles only
By:
Search titles only
By:
Menu
Install the app
Install
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Forums
Jeep Wrangler YJ
YJ Build Threads & Member's Rides
Heavy Duty Steering
Reply to thread
Message
<blockquote data-quote="Ben Venner" data-source="post: 437372" data-attributes="member: 20830"><p>Hello all, I'm working on updating my steering on my 95 YJ. I am going to use a kit from RuffStuff. The kit is a one ton kit that uses GM one ton tie rod ends. The kit requires me to cut my own tubing that they send, and weld in the ends, which is all fine. If I decide to mount the tie rods under the knuckle in stock configuration, I will not have to bend my tubing, whereas over the knuckle I will have to bend most likely. So, my question is this, are there measurements for the lengths of the tubing for the drag link and the tie rod bar, or am I better off measuring my stock one and going from there? if there's already a thread on this, I apologize, please point me in that direction. </p><p></p><p></p><p>Thanks,</p><p>-B</p></blockquote><p></p>
[QUOTE="Ben Venner, post: 437372, member: 20830"] Hello all, I'm working on updating my steering on my 95 YJ. I am going to use a kit from RuffStuff. The kit is a one ton kit that uses GM one ton tie rod ends. The kit requires me to cut my own tubing that they send, and weld in the ends, which is all fine. If I decide to mount the tie rods under the knuckle in stock configuration, I will not have to bend my tubing, whereas over the knuckle I will have to bend most likely. So, my question is this, are there measurements for the lengths of the tubing for the drag link and the tie rod bar, or am I better off measuring my stock one and going from there? if there's already a thread on this, I apologize, please point me in that direction. Thanks, -B [/QUOTE]
Verification
Post reply
Forums
Jeep Wrangler YJ
YJ Build Threads & Member's Rides
Heavy Duty Steering
Top
Bottom