Forums
New posts
Search forums
Image search
Shop
Amazon Store
T-Shirts
Stickers
Members
Current visitors
Supporting Member Upgrade
Sponsors
About
Log in
Register
Search
Search titles only
By:
Search titles only
By:
New posts
Search forums
Image search
Search
Search titles only
By:
Search titles only
By:
Menu
Install the app
Install
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Forums
Jeep Wrangler YJ
YJ General Discussion
Getting ready while the engine head is the shop
Reply to thread
Message
<blockquote data-quote="Gilaguy23" data-source="post: 439262" data-attributes="member: 19498"><p>Ive used a shop vac which worked fine. Do your best to remove any carbon chunks. DO NOT use a wire wheel on the deck of the block, use a painters razor holder and scrape till free of gasket material and then use something like brake clean to wipe it off.</p></blockquote><p></p>
[QUOTE="Gilaguy23, post: 439262, member: 19498"] Ive used a shop vac which worked fine. Do your best to remove any carbon chunks. DO NOT use a wire wheel on the deck of the block, use a painters razor holder and scrape till free of gasket material and then use something like brake clean to wipe it off. [/QUOTE]
Verification
Post reply
Forums
Jeep Wrangler YJ
YJ General Discussion
Getting ready while the engine head is the shop
Top
Bottom