Forums
New posts
Search forums
Image search
Shop
Amazon Store
T-Shirts
Stickers
Members
Current visitors
Supporting Member Upgrade
Sponsors
About
Log in
Register
Search
Search titles only
By:
Search titles only
By:
New posts
Search forums
Image search
Search
Search titles only
By:
Search titles only
By:
Menu
Install the app
Install
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Forums
Jeep Wrangler YJ
YJ General Discussion
Every time a fellow member has a problem with their YJ my YJ seems to do the same thing!
Reply to thread
Message
<blockquote data-quote="Flyer58" data-source="post: 439345" data-attributes="member: 18629"><p>Well I did track the problem down to that pump three wire connector but didn't fix the problem. I cleaned and sprayed a corrosion inhibitor in both side of the plug but found there must be a loose connection somewhere in or around the plug. By jumping the relay I can hear the pump running but if I lightly tap the connector the pump will momentarily cut out or stop all together. The two halves are a tight fit with no wiggle room so it might be where the wire go into the plug and it could be on either side. I don't think it's up or down stream from the plug. There's little to no slack going towards the pump and no change if I pull that end of the harness so I believe the ground connection and the tank is still holding tight. </p><p></p><p>I'll check it closer with a multi meter and maybe need to change the connector.</p><p></p><p>[ATTACH=full]121756[/ATTACH]</p></blockquote><p></p>
[QUOTE="Flyer58, post: 439345, member: 18629"] Well I did track the problem down to that pump three wire connector but didn't fix the problem. I cleaned and sprayed a corrosion inhibitor in both side of the plug but found there must be a loose connection somewhere in or around the plug. By jumping the relay I can hear the pump running but if I lightly tap the connector the pump will momentarily cut out or stop all together. The two halves are a tight fit with no wiggle room so it might be where the wire go into the plug and it could be on either side. I don't think it's up or down stream from the plug. There's little to no slack going towards the pump and no change if I pull that end of the harness so I believe the ground connection and the tank is still holding tight. I'll check it closer with a multi meter and maybe need to change the connector. [ATTACH type="full" alt="6.jpg"]121756[/ATTACH] [/QUOTE]
Verification
Post reply
Forums
Jeep Wrangler YJ
YJ General Discussion
Every time a fellow member has a problem with their YJ my YJ seems to do the same thing!
Top
Bottom