Forums
New posts
Search forums
Image search
Shop
Amazon Store
T-Shirts
Stickers
Members
Current visitors
Supporting Member Upgrade
Sponsors
About
Log in
Register
Search
Search titles only
By:
Search titles only
By:
New posts
Search forums
Image search
Search
Search titles only
By:
Search titles only
By:
Menu
Install the app
Install
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Forums
Jeep Wrangler YJ
YJ General Discussion
87 YJ engine swap to 350 sb
Reply to thread
Message
<blockquote data-quote="Bryan87YJ" data-source="post: 433137" data-attributes="member: 20035"><p>I have swapped to a 350 sb in my 87. It is currently married to a gm transmission which is very low geared. I want to put my AX15 behind the 350. The adapter plate which allows me to use my AX15 bell housing is about 2 inches thick. If i use this adapter it will pull the transmission shaft out of the pilot bearing. Is there a fix for this?</p></blockquote><p></p>
[QUOTE="Bryan87YJ, post: 433137, member: 20035"] I have swapped to a 350 sb in my 87. It is currently married to a gm transmission which is very low geared. I want to put my AX15 behind the 350. The adapter plate which allows me to use my AX15 bell housing is about 2 inches thick. If i use this adapter it will pull the transmission shaft out of the pilot bearing. Is there a fix for this? [/QUOTE]
Verification
Post reply
Forums
Jeep Wrangler YJ
YJ General Discussion
87 YJ engine swap to 350 sb
Top
Bottom