Forums
New posts
Search forums
Image search
Shop
Amazon Store
T-Shirts
Stickers
Members
Current visitors
Supporting Member Upgrade
Sponsors
About
Log in
Register
Search
Search titles only
By:
Search titles only
By:
New posts
Search forums
Image search
Search
Search titles only
By:
Search titles only
By:
Menu
Install the app
Install
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Forums
Jeep Wrangler YJ
YJ General Discussion
87 wrangler ubolts
Reply to thread
Message
<blockquote data-quote="machoheadgames" data-source="post: 433208" data-attributes="member: 18789"><p>Existing ubolts should be based on the axle tube and should be roughly 2.5"ish....take pictures of your axles to see if you are not on stock axles. 2" tubes would be really small.</p><p></p><p>usually you get 4 2.5" ubolts for the rear axle and then 2 2.5" for the front and 2 3.25" for the front. The front has you place the ubolts over the thicker housing castings like the pumpkin on the left side and the CAD housing on the right side, hence the different size bolts needed. Haven't ever needed a 2.75" bolt on my jeep.</p></blockquote><p></p>
[QUOTE="machoheadgames, post: 433208, member: 18789"] Existing ubolts should be based on the axle tube and should be roughly 2.5"ish....take pictures of your axles to see if you are not on stock axles. 2" tubes would be really small. usually you get 4 2.5" ubolts for the rear axle and then 2 2.5" for the front and 2 3.25" for the front. The front has you place the ubolts over the thicker housing castings like the pumpkin on the left side and the CAD housing on the right side, hence the different size bolts needed. Haven't ever needed a 2.75" bolt on my jeep. [/QUOTE]
Verification
Post reply
Forums
Jeep Wrangler YJ
YJ General Discussion
87 wrangler ubolts
Top
Bottom