So, I posted this is another platform and I have received no responses, so I'm here checking on this forum.
1995 Wrangler YJ Sahara 4.0L auto trans. Forgive me, but I am new to the Jeep family. My brother who convinced me to buy this Jeep has passed and now I don't have that source of knowledge any longer. My issue: when I shift into reverse, the jeep begins backing up fine for about 5-10 seconds and then the idle gets a little wonky and it acts as if it wants to shut down. Sometimes it will shut down. If I stop and immediately shift it to drive it will shut down. It runs fine and idles fine. It just has this reverse issue.
Below is what I have done so far since I purchased this Jeep several months ago:
Changed transmission fluid and filter / oil and filter / new plugs and wires / new coolant system hoses and fluid / new thermostat / new coolant temp sensor and sender / changed diff fluid and seals front and rear / new TPS / new CPS / new manifold air temp sensor / new O2 sensor / new MAP sensor / new idle speed motor / replaced some of the vacuum connections that were questionable
There are a few other changes I've made, but these are the more mechanical/engine related ones. PLEASE HELP!!! THANKS!!
1995 Wrangler YJ Sahara 4.0L auto trans. Forgive me, but I am new to the Jeep family. My brother who convinced me to buy this Jeep has passed and now I don't have that source of knowledge any longer. My issue: when I shift into reverse, the jeep begins backing up fine for about 5-10 seconds and then the idle gets a little wonky and it acts as if it wants to shut down. Sometimes it will shut down. If I stop and immediately shift it to drive it will shut down. It runs fine and idles fine. It just has this reverse issue.
Below is what I have done so far since I purchased this Jeep several months ago:
Changed transmission fluid and filter / oil and filter / new plugs and wires / new coolant system hoses and fluid / new thermostat / new coolant temp sensor and sender / changed diff fluid and seals front and rear / new TPS / new CPS / new manifold air temp sensor / new O2 sensor / new MAP sensor / new idle speed motor / replaced some of the vacuum connections that were questionable
There are a few other changes I've made, but these are the more mechanical/engine related ones. PLEASE HELP!!! THANKS!!