Forums
New posts
Search forums
Image search
Shop
Amazon Store
T-Shirts
Stickers
Members
Current visitors
Supporting Member Upgrade
Sponsors
About
Log in
Register
Search
Search titles only
By:
Search titles only
By:
New posts
Search forums
Image search
Search
Search titles only
By:
Search titles only
By:
Menu
Install the app
Install
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Forums
Jeep Wrangler YJ
YJ General Discussion
1995 Sahara auto to manual swap
Reply to thread
Message
<blockquote data-quote="Plastic Fury" data-source="post: 440849" data-attributes="member: 21352"><p>I was looking at the other thread where you were discussing the wiring needed to ground the starter relay and setup the reverse lights, etc.</p><p></p><p>For the brown/yellow starter wire, instead of running it to the black/orange Z2 wire, I was planning to run it up through the firewall and into the cab to use as a "kill switch" toggle to disrupt the ground when desired.</p><p></p><p>The blue torque converter wire I know just needs to be cut and heat shrinked and then pull the TCC relay from the harness on the firewall.</p><p></p><p>For the keyed power and backup light wire, I have a painless 2 pin male weather pack but with this new Novak AX15 I am not sure which wire is which to match it up to the pinned connector?</p></blockquote><p></p>
[QUOTE="Plastic Fury, post: 440849, member: 21352"] I was looking at the other thread where you were discussing the wiring needed to ground the starter relay and setup the reverse lights, etc. For the brown/yellow starter wire, instead of running it to the black/orange Z2 wire, I was planning to run it up through the firewall and into the cab to use as a "kill switch" toggle to disrupt the ground when desired. The blue torque converter wire I know just needs to be cut and heat shrinked and then pull the TCC relay from the harness on the firewall. For the keyed power and backup light wire, I have a painless 2 pin male weather pack but with this new Novak AX15 I am not sure which wire is which to match it up to the pinned connector? [/QUOTE]
Verification
Post reply
Forums
Jeep Wrangler YJ
YJ General Discussion
1995 Sahara auto to manual swap
Top
Bottom