Search results

how do you check for codes

I pulled every connection apart and cleaned them , replaced all the fusible links, added some new grounds, bought a repaired computer from wrangler fix. The cps has the correct ohm rating, the coil is new. the emiss main light comes on and i hear the fuel pump cycle. Could the previous owner...

The previous owner stated that he put a new clutch in and it would not start. He had replaced the crank position sensor, coil, cap rotor and wires. I pulled every connection apart and cleaned them. I replaced all of the fusible links, and a few bare and broken wires. there were signs of some bad...

I looked on ebay and the pcms for the 4 cylinder 89 used are over $400 or i can send mine to be repaired for $150 or a new one at autozone is $150 so why are the used ones so much

is there a different check engine light than the "emiss maint" light if there is and it doesnt come on should i just replace the pcm because it has a new cps, coil, cap and wires

the only light that come one when turn the key on is "emiss check" is there a different check engine light

the coil checked good but i put a new one on anyway to try it

No spark at all, battery full charge, it has gas no gas in injector but gas is circulating to the injector, will not start because of no spark to plugs, checked every fuse and relay, the person stated that it ran before he put the new clucth in. it cranks over good and has good compression just...

no cel, no codes. there are just 2 bolts holding the cps in place. I just wondered if the person putting the clutch in goofed something up. the cps bolts in at the back of the engine near the flywheel so didnt know where it gets its signal from.

I bought a 89 yj with the 4 cylinder. The person I bought it from stated they put a new clutch in it and could not get it to start. There is no spark. It has a new coil, cap and rotor.Could he have done something wrong to the crank position sensor while installing the clutch? I checked the CPS...