Recent content by yjfever

Hi. From your AI quote it reads "Spacer Use: If the push rod seems too short, check if your Jeep requires a spacer between the slave cylinder and the transmission case"... I don't believe this statement...as we discussed earlier.Anyway, symptom is lessening as clutch disk wears out...

Thank you...YJ Addict: both master and slave cylinder are new. It is an external slave as indicated on my post. An expert suggested me to put 2 washers between the slave and the bellcase like a spacer to move back the slave. Not sure if this may work. Believe the situation will get...

Just swaped to an AX15 on my 1989 YJ jeep. Having the clutch too tight: engaging with pedal ½ inch from the floor. Gears grind most of the times. Slave was bleeded correctly following manufacturing instructions...no air in clutch line. Any easy solution to this situation? Thank you. Note...

Macho...just want to make sure I order the right synchros...there is a lot of debris gold-like small particles in tranny oil. Can you advise on what vendor/part number? Thank you.

Hi. Got this tranny with transfer case but seems it is not its original t-case. Can see the following number on tranny left near the t- case: 00802748. Those are the only numbers found on it. Does this number bring some light? Thank you.

Hof. Dont know donor, tranny does not have any number nowhere, the suppossed number ubder the intermediate plate is totally erased. Please see attached pics if you con get me ahead. Thank you. I am concerned about manufacturing date so I order correct repair kit.

Hi everybody: Just got one AX15 tranny and need its manufacturing date to order correct repair kit. The number embossed under the case is totally illegible, seems tranny was transported over a metal surface. Is there any other way to identify this transmission. Any help will be greatly appreciated.

Chris: Thank you for your input trying to help me. Your alternatives are all inclusive, I believe, and firstly will try the Epoxy suggestion in hope that it will fix the damage. Reading on this for a while I have seen many difficult situations solved by forum members. Would you to go deeper on...

Dear fellows: My YJ Jeep is leaking oil even with new oil pan gasket correctly installed. After removing rear main Bearing, found that the two ribs or rims indicated in red were broken in both block sides, probably trying to remove rear oil seal that goes over the crankshaft. Any ideas on how to...

My cooling system is ok. No coolant loose, no overheating. Thank you.

HI. Just seen some water mixed with carbon coming out of my 1989 YJ exhaust pipe. It appears evey day at any time. Please advise what it should be. Thank you.