Latest activity Postings Images About
-
-
tygersquirt replied to the thread 94 YJ 4.0 overheating.None taken, I was just covering all my bases to ensure no damage was being done to the motor. I appreciate the help! -
No offense, but as I said at the beginning the fist thingI do in a situation like this is install a man. Temp gauge. I have an old...
-
tygersquirt replied to the thread 94 YJ 4.0 overheating.Well, considering the temp gun is reading correctly, the only other issue it could be is a faulty temp sending unit, or gauge in the...
-
tygersquirt replied to the thread 94 YJ 4.0 overheating.Update; New 195F Thermostat, burped, cooled, burped, cooled, burped. Still reading 260F+ Temp readings are as follows; Thermostat...
-
tygersquirt replied to the thread 94 YJ 4.0 overheating.This will be the third time burping. I’m letting it cool down at the moment and heading to the parts store to grab another TStat to try...
-
tygersquirt replied to the thread 94 YJ 4.0 overheating.Another update; I am not so sure my thermostats are actually opening up once installed. I’ve put in both of the ones I have, and while...
-
My 94 YJ had very much the same issue.... I had upgraded (or maybe actually a down grade) to a flowcool water pump and IIRC a colder...
-
tygersquirt replied to the thread 94 YJ 4.0 overheating.Have not flushed the radiator yet. Doing this now and will update temps after burping.
-
tygersquirt replied to the thread 94 YJ 4.0 overheating.Update; after driving 5 miles and idling for 20 minutes, temps with IR Gun are as follows; (all temps taken multiple times and within a...
-
tygersquirt replied to the thread Machine shop services.Not sure if you've taken it to the shop yet, but all you really need them to do is deck the head. I just did a full rebuild on my 4.0...
-
tygersquirt replied to the thread 94 YJ 4.0 overheating.Sorry for the late response, been super busy at work but have the next four days off. I wasn't trying to say it was an issue, I was...
-
use deep wall socket, and not break the plastic 1 pin connector. okay?
-
tygersquirt replied to the thread 94 YJ 4.0 overheating.No Teflon or sealant was used for the two temp sensors. I’ll give them a good clean and give it a try. I read online that the...
-
The temp for the gauge is only read off of resistance to ground. The wire from the gauge to the sender is a ground wire for the gauge...
-
tygersquirt replied to the thread 94 YJ 4.0 overheating.That will be my next step. Thanks for the input. Thought just crossed my mind, does the temp sensor have a ground wire? If so, mine...
-
-
Loading…
-
Loading…
-
Loading…
