You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser.
-
-
S
Good job my friend. I also am going through some similar situations with a newly rebuilt 2.5 install. Ran great during break in time...
-
S
Well I did what I was afraid to do... I pulled the valve cover this morning and no. 3 cylinder has a bent pushrod and will be removing...
-
S
Distributor was never loosely
It seems a little weird that the tab on the rotor is so wide. But I guess it works. I set the timing up...
-
S
Have you double checked all the connections you undid when you swapped engines? Pop the dist cap off and see how much play is in the...
-
S
My recommendation is to private message macoheadgames and ask him for advice. On the EFI engines he is about as knowledgeable as anyone...
-
S
It seems to be a random sputter and it does it from the moment it starts. Nothing to do with warming up and then starting trouble. It's...
-
S
All was good meaning no vacuum leaks but l am trying to keep up here I promise, this is just stuff that is sort of new to me and the...
-
S
since then, I have reset the computer by disconecting battery terminals and put positive cable to negative for 30 sec. and then turned...
-
S
yes sir, checked it for vacuume leaks and repaired and checked again. Took the manifold back off to replace the gasket again and inspect...
-
S
Hello and thank you for letting me post here.
I just put a new 2.5l long block in my 89 wrangler and it started up and ran fine. I...
-
Loading…
-
Loading…