Gilaguy23
YJ Addict 63 From Q town New Mexico
Latest activity Postings Images About
-
-
Gilaguy23 replied to the thread Getting my Jeep running again after sitting up for three years.That's about the size of it. Does it turn over? Why was it parked? Check the intake system for rat/mice nests for sure. If it wont run... -
Gilaguy23 reacted to machoheadgames's post in the thread Getting my Jeep running again after sitting up for three years with
Like.
Well, does it start? If it starts and runs fine, then you don’t need to do anything. If it doesn’t then you need to figure out what’s wrong. -
Finished the rebuild on my 89 258. Rings, bearings, valve lap, and new Comp Cams rock crawler cam. Got the ol pig fired up and run for...
-
Gilaguy23 replied to the thread Windshield frame to tailgate measurement.I think bestops website has that spec as well.
-
Gilaguy23 replied to the thread Billet fuel rail.Performance improvement to the sellers bank account maybe??
-
Gilaguy23 replied to the thread Driver seat off-centered vs the steering wheel.Kinda how they are. Look at the base where the seats are bolted to the tub and you can see how/where they bolt down. Could you move...
-
Gilaguy23 replied to the thread Unknown Ground Wire On Steering Column.Like Macho said,that ring terminal if definitely an OEM job. If that the only hack job on your YJ consider yourself very lucky . ;)
-
Gilaguy23 replied to the thread Help identifying vacuum leak.Its a check valve basically. Ive nabbed a few off other vehicles over the years at junk yards. Finding t hat particular one for a YJ may...
-
Gilaguy23 replied to the thread Rust bucket.For your safetys sake you and pupps ;) , really need to have the frame checked out. Nobodys knocking your jeep, its just a fact of...
-
As you live by the beach, salt is the enemy of steel. Fortunately, your pictures didn't show a lot of rust. The parts under the engine...
-
Remove the bolt before assembling them together. The bolt may been stopping it from sliding all the way on. The groove in the shaft is...
-
Gilaguy23 replied to the thread Intermediate to Wormshaft Connection.As you said Macho, IIRC the upper shaft has a slip joint of sorts. It might be rusted up and not move either but Id be pretty reluctant...
-
Gilaguy23 replied to the thread Intermediate to Wormshaft Connection.I dont believe that is right. I'm guessing you have very little contact or overlap in the two and I wanna say the unsplined area in the...
-
Gilaguy23 reacted to machoheadgames's post in the thread Abnormal engine temperatures on 1995 YJ 4.0 with Like.
Sounds like the thermostat you got is faulty, I would swap it again. The thermostat is the only part that can cause over cooling, by...
-
Gilaguy23 replied to the thread Abnormal engine temperatures on 1995 YJ 4.0.You should use a 195 which is 90ish Celsius thermostat correct? A couple of things., The new thermo was mis boxed, did you see the 195...
-
-
Loading…
-
Loading…
-
Loading…