Forums
New posts
Search forums
Image search
Shop
Amazon Store
T-Shirts
Stickers
Members
Current visitors
Supporting Member Upgrade
Sponsors
About
Log in
Register
Search
Search titles only
By:
Search titles only
By:
New posts
Search forums
Image search
Search
Search titles only
By:
Search titles only
By:
Menu
Install the app
Install
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Forums
Jeep Wrangler YJ
YJ General Discussion
YJ engine swap
Reply to thread
Message
<blockquote data-quote="Mudtug" data-source="post: 429676" data-attributes="member: 19584"><p>Hi All,</p><p>I have a 91 YJ that currently has a 4” lift, 33” tires. It came with a 2,5L,Ax-15 and NP231 running 4:11 gears in the Dana 30 front and 35 rear.</p><p></p><p>i want to swap the engine and tranny out with a 4L i6 and AX15 (reusing the Np231). The engine I have is out of a 97 TJ. I understand the engine mounts will change. Like my exhaust will change as well obviously.i have the powertrain wiring harness for the 97 (cam pos sensor, crank position sensor, speedo, etc.).</p><p></p><p>The question is; will the PCM /ECM from the 97 TJ work with the other two body harnesses? I know the TJ uses a digital 2 wire CCD to run all the gauges on the dashboard, pretty sure the 91 does not use that same technology. OR do I need a PCM from a YJ series jeep?</p><p></p><p>the YJ is 30 years old, so no emissions inspections are required, thankfully.</p><p>Would appreciate some input from the mechanical gurus on this forum.</p><p></p><p>thank you,</p><p>Mike</p></blockquote><p></p>
[QUOTE="Mudtug, post: 429676, member: 19584"] Hi All, I have a 91 YJ that currently has a 4” lift, 33” tires. It came with a 2,5L,Ax-15 and NP231 running 4:11 gears in the Dana 30 front and 35 rear. i want to swap the engine and tranny out with a 4L i6 and AX15 (reusing the Np231). The engine I have is out of a 97 TJ. I understand the engine mounts will change. Like my exhaust will change as well obviously.i have the powertrain wiring harness for the 97 (cam pos sensor, crank position sensor, speedo, etc.). The question is; will the PCM /ECM from the 97 TJ work with the other two body harnesses? I know the TJ uses a digital 2 wire CCD to run all the gauges on the dashboard, pretty sure the 91 does not use that same technology. OR do I need a PCM from a YJ series jeep? the YJ is 30 years old, so no emissions inspections are required, thankfully. Would appreciate some input from the mechanical gurus on this forum. thank you, Mike [/QUOTE]
Verification
Post reply
Forums
Jeep Wrangler YJ
YJ General Discussion
YJ engine swap
Top
Bottom