Forums
New posts
Search forums
Image search
Shop
Amazon Store
T-Shirts
Stickers
Members
Current visitors
Supporting Member Upgrade
Sponsors
About
Log in
Register
Search
Search titles only
By:
Search titles only
By:
New posts
Search forums
Image search
Search
Search titles only
By:
Search titles only
By:
Menu
Install the app
Install
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Forums
Jeep Wrangler YJ
YJ General Discussion
What gear should my 92 yj 5 speed be in to tow
Reply to thread
Message
<blockquote data-quote="Gilaguy23" data-source="post: 431116" data-attributes="member: 19498"><p>Couldent resist this one. </p><p></p><p><strong>By Nanci Dixon</strong></p><p>A 2021 Jeep Rubicon with less than 10,000 miles was recently brought in for service to a dealer in Florida. The Jeep was in for repair after being flat towed behind an RV. What the owner found out should scare everyone with a tow vehicle. Read carefully.</p><p></p><p>Jeeps are known for their ease of flat towing, but only when the directions are followed. Instead of neutral, the owner had put the Jeep into 4-Low. Jeep clearly states in the owner’s manual, “Do not go over 25 MPH in 4-Low.”</p><p></p><p>Pulling in 4-Low at 55 MPH or more revved the engine to over 50,000 RPMs. The factory redline is 6,000 RPMs. As the wheels turned so did the driveshaft and transmission. The engine was rotated.</p><p></p><p></p><p>The crankshaft was sheared off. Pistons and rods went through the block. The clutch and flywheel slammed into the transmission bell housing and took out the input shaft. The back of block gone and the convertor hit. Flat towing in the wrong gear basically destroyed the engine.</p><p></p><p>The repair and replacement cost was more than $30,000 just on parts alone! Nope, the factory warranty doesn’t count here and it’s unknown how insurance will handle it.</p></blockquote><p></p>
[QUOTE="Gilaguy23, post: 431116, member: 19498"] Couldent resist this one. [B]By Nanci Dixon[/B] A 2021 Jeep Rubicon with less than 10,000 miles was recently brought in for service to a dealer in Florida. The Jeep was in for repair after being flat towed behind an RV. What the owner found out should scare everyone with a tow vehicle. Read carefully. Jeeps are known for their ease of flat towing, but only when the directions are followed. Instead of neutral, the owner had put the Jeep into 4-Low. Jeep clearly states in the owner’s manual, “Do not go over 25 MPH in 4-Low.” Pulling in 4-Low at 55 MPH or more revved the engine to over 50,000 RPMs. The factory redline is 6,000 RPMs. As the wheels turned so did the driveshaft and transmission. The engine was rotated. The crankshaft was sheared off. Pistons and rods went through the block. The clutch and flywheel slammed into the transmission bell housing and took out the input shaft. The back of block gone and the convertor hit. Flat towing in the wrong gear basically destroyed the engine. The repair and replacement cost was more than $30,000 just on parts alone! Nope, the factory warranty doesn’t count here and it’s unknown how insurance will handle it. [/QUOTE]
Verification
Post reply
Forums
Jeep Wrangler YJ
YJ General Discussion
What gear should my 92 yj 5 speed be in to tow
Top
Bottom