Forums
New posts
Search forums
Image search
Shop
Amazon Store
T-Shirts
Stickers
Members
Current visitors
Supporting Member Upgrade
Sponsors
About
Log in
Register
Search
Search titles only
By:
Search titles only
By:
New posts
Search forums
Image search
Search
Search titles only
By:
Search titles only
By:
Menu
Install the app
Install
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Forums
Jeep Wrangler YJ Resources
YJ Resources
Troubleshooting Your Jeep YJ Turn / Hazard / Brake Light Systems
Reply to thread
Message
<blockquote data-quote="Deep Obsession 1" data-source="post: 432032" data-attributes="member: 19893"><p>I installed new LED tail lights on my 94 YJ. Brake lights work when pedal is pressed. Turn signals both sides work when lever is pushed. But the turn signals will not work with the brake pedal pushed. I found a bunch of really bad wiring issues in back so I cut it all out. Someone hacked it up bad. I tested the factory wires and figured out what did what then hooked up the new LED tail lights. First issue I found was when I turned on the turn signals they both flashed. So after a little thinking I realized they need a diode to stop the current flow back through the brake wires since brake and turn share one wire at the lights. I installed 2 diodes and now brake and turn work separately but they don't play well together. So that's where I'm at.</p><p>Any ideas?</p></blockquote><p></p>
[QUOTE="Deep Obsession 1, post: 432032, member: 19893"] I installed new LED tail lights on my 94 YJ. Brake lights work when pedal is pressed. Turn signals both sides work when lever is pushed. But the turn signals will not work with the brake pedal pushed. I found a bunch of really bad wiring issues in back so I cut it all out. Someone hacked it up bad. I tested the factory wires and figured out what did what then hooked up the new LED tail lights. First issue I found was when I turned on the turn signals they both flashed. So after a little thinking I realized they need a diode to stop the current flow back through the brake wires since brake and turn share one wire at the lights. I installed 2 diodes and now brake and turn work separately but they don't play well together. So that's where I'm at. Any ideas? [/QUOTE]
Verification
Post reply
Forums
Jeep Wrangler YJ Resources
YJ Resources
Troubleshooting Your Jeep YJ Turn / Hazard / Brake Light Systems
Top
Bottom