Forums
New posts
Search forums
Image search
Shop
Amazon Store
T-Shirts
Stickers
Members
Current visitors
Supporting Member Upgrade
Sponsors
About
Log in
Register
Search
Search titles only
By:
Search titles only
By:
New posts
Search forums
Image search
Search
Search titles only
By:
Search titles only
By:
Menu
Install the app
Install
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Forums
Jeep Wrangler YJ
YJ General Discussion
Reproductions of discontinued exhaust hangers
Reply to thread
Message
<blockquote data-quote="Gman" data-source="post: 435824" data-attributes="member: 20497"><p>Well, this is what I can share with you but remember, there is no material left for where the bolt holes were. The part in the picture looks like an original part. The distance between the two holes (C-C) is 2.5". I believe that the lower hole is 3/4" - 7/8" from the vertical section where the vice grips are to the center of the hole (left to right). The center of lower hole is approximately 1" up from the bottom of the horizontal plate (outside bottom). When you say the distance from the lower hole over to the piece on the lower right of the picture, you are speaking of the "half" pipe bracket the goes into the rubber isolator? I can't give you that measurement, but I could provide you with the distance from the bottom end (far left) of the plate to the center of the half pipe. On another note, can you make the tailpipe hanger? Went to take mine off last Friday and it turned into a pile of rust.</p><p></p><p></p><p>[ATTACH=full]120260[/ATTACH][ATTACH=full]120261[/ATTACH]</p></blockquote><p></p>
[QUOTE="Gman, post: 435824, member: 20497"] Well, this is what I can share with you but remember, there is no material left for where the bolt holes were. The part in the picture looks like an original part. The distance between the two holes (C-C) is 2.5". I believe that the lower hole is 3/4" - 7/8" from the vertical section where the vice grips are to the center of the hole (left to right). The center of lower hole is approximately 1" up from the bottom of the horizontal plate (outside bottom). When you say the distance from the lower hole over to the piece on the lower right of the picture, you are speaking of the "half" pipe bracket the goes into the rubber isolator? I can't give you that measurement, but I could provide you with the distance from the bottom end (far left) of the plate to the center of the half pipe. On another note, can you make the tailpipe hanger? Went to take mine off last Friday and it turned into a pile of rust. [ATTACH type="full"]120260[/ATTACH][ATTACH type="full"]120261[/ATTACH] [/QUOTE]
Verification
Post reply
Forums
Jeep Wrangler YJ
YJ General Discussion
Reproductions of discontinued exhaust hangers
Top
Bottom