Forums
New posts
Search forums
Image search
Shop
Amazon Store
T-Shirts
Stickers
Members
Current visitors
Supporting Member Upgrade
Sponsors
About
Log in
Register
Search
Search titles only
By:
Search titles only
By:
New posts
Search forums
Image search
Search
Search titles only
By:
Search titles only
By:
Menu
Install the app
Install
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Forums
Jeep Wrangler YJ
YJ General Discussion
Rear wiper dash switch wires
Reply to thread
Message
<blockquote data-quote="Kkelly66" data-source="post: 431192" data-attributes="member: 19783"><p>I'm troubleshooting why my rear wiper runs constantly when harness is plugged in (with key on). I have no power to the switch on the dash. I know that the green/white goes to the wiper, and think the brown/white goes to the rear harness but not sure what it does in the hard top (washer?).</p><p>I'm thinking the black is ground. The red/white? Should this be power? I can't figure out where it goes. </p><p>If so can I just connect it to a wire the I know is hot with the key on? Thanks</p></blockquote><p></p>
[QUOTE="Kkelly66, post: 431192, member: 19783"] I'm troubleshooting why my rear wiper runs constantly when harness is plugged in (with key on). I have no power to the switch on the dash. I know that the green/white goes to the wiper, and think the brown/white goes to the rear harness but not sure what it does in the hard top (washer?). I'm thinking the black is ground. The red/white? Should this be power? I can't figure out where it goes. If so can I just connect it to a wire the I know is hot with the key on? Thanks [/QUOTE]
Verification
Post reply
Forums
Jeep Wrangler YJ
YJ General Discussion
Rear wiper dash switch wires
Top
Bottom