Forums
New posts
Search forums
Image search
Shop
Amazon Store
T-Shirts
Stickers
Members
Current visitors
Supporting Member Upgrade
Sponsors
About
Log in
Register
Search
Search titles only
By:
Search titles only
By:
New posts
Search forums
Image search
Search
Search titles only
By:
Search titles only
By:
Menu
Install the app
Install
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Forums
Jeep Wrangler YJ
YJ General Discussion
Rear sway bar removal grumble grumble
Reply to thread
Message
<blockquote data-quote="Flyer58" data-source="post: 430602" data-attributes="member: 18629"><p>More grumbles. I should have stayed in bed.</p><p></p><p>I'll drive around and see if I notice any difference without the track bar. It's more about off road wheel travel without the bar so there should be no difference on flat roads.</p><p></p><p>I ordered a Walker exhaust through RockAuto and received most of it except the end tailpipe. Looking at the front pipe where the O2 sensor is located I found they crushed the snot out of it to make a flat spot to weld on the O2 bung. I called Walker and they agreed it was beyond the spec by double. So I boxed up the front pipe and got the exchange going through RockAuto. Hopefully this is a one time event and not an automated process where the last 100 were all made wrong. They crush the 2in pipe down to 1.5 inches and for a 2.5L i don't need any further restrictions. </p><p></p><p>[ATTACH=full]118032[/ATTACH]</p></blockquote><p></p>
[QUOTE="Flyer58, post: 430602, member: 18629"] More grumbles. I should have stayed in bed. I'll drive around and see if I notice any difference without the track bar. It's more about off road wheel travel without the bar so there should be no difference on flat roads. I ordered a Walker exhaust through RockAuto and received most of it except the end tailpipe. Looking at the front pipe where the O2 sensor is located I found they crushed the snot out of it to make a flat spot to weld on the O2 bung. I called Walker and they agreed it was beyond the spec by double. So I boxed up the front pipe and got the exchange going through RockAuto. Hopefully this is a one time event and not an automated process where the last 100 were all made wrong. They crush the 2in pipe down to 1.5 inches and for a 2.5L i don't need any further restrictions. [ATTACH type="full"]118032[/ATTACH] [/QUOTE]
Verification
Post reply
Forums
Jeep Wrangler YJ
YJ General Discussion
Rear sway bar removal grumble grumble
Top
Bottom