Forums
New posts
Search forums
Image search
Shop
Amazon Store
T-Shirts
Stickers
Members
Current visitors
Supporting Member Upgrade
Sponsors
About
Log in
Register
Search
Search titles only
By:
Search titles only
By:
New posts
Search forums
Image search
Search
Search titles only
By:
Search titles only
By:
Menu
Install the app
Install
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Forums
Jeep Wrangler YJ
YJ General Discussion
Rear pinion angle, CV drive shaft length questions
Reply to thread
Message
<blockquote data-quote="mvez" data-source="post: 436247" data-attributes="member: 20613"><p>Tcase drop removed. Def effected the driveshaft angle more than I expected. I think the driveshaft itself still has splay left in it but I'll lift the frame next to test that. </p><p></p><p>I took measurements of the pinion and DS angle. I'm not sure it's the best spot to do it but maybe one of y'all can advise on that. My angle finder is now showing the pinion angle to be about 5-6 degrees lower than the DS, to but please let me know if I could be measuring this in a better place. </p><p>Anyway, So im now in the opposite situation than original post. Is this too much angle? I haven't drove the jeep yet but What issues could I run into when driving it? If it's too much would new axle shims be the best fix?</p><p>I've attached pictures</p><p></p><p>[ATTACH=full]120470[/ATTACH]</p><p></p><p>[ATTACH=full]120471[/ATTACH]</p><p></p><p>[ATTACH=full]120472[/ATTACH]</p><p></p><p>[ATTACH=full]120473[/ATTACH]</p><p></p><p>[ATTACH=full]120474[/ATTACH]</p></blockquote><p></p>
[QUOTE="mvez, post: 436247, member: 20613"] Tcase drop removed. Def effected the driveshaft angle more than I expected. I think the driveshaft itself still has splay left in it but I'll lift the frame next to test that. I took measurements of the pinion and DS angle. I'm not sure it's the best spot to do it but maybe one of y'all can advise on that. My angle finder is now showing the pinion angle to be about 5-6 degrees lower than the DS, to but please let me know if I could be measuring this in a better place. Anyway, So im now in the opposite situation than original post. Is this too much angle? I haven't drove the jeep yet but What issues could I run into when driving it? If it's too much would new axle shims be the best fix? I've attached pictures [ATTACH=full]120470[/ATTACH] [ATTACH=full]120471[/ATTACH] [ATTACH=full]120472[/ATTACH] [ATTACH=full]120473[/ATTACH] [ATTACH=full]120474[/ATTACH] [/QUOTE]
Verification
Post reply
Forums
Jeep Wrangler YJ
YJ General Discussion
Rear pinion angle, CV drive shaft length questions
Top
Bottom