Forums
New posts
Search forums
Image search
Shop
Amazon Store
T-Shirts
Stickers
Members
Current visitors
Supporting Member Upgrade
Sponsors
About
Log in
Register
Search
Search titles only
By:
Search titles only
By:
New posts
Search forums
Image search
Search
Search titles only
By:
Search titles only
By:
Menu
Install the app
Install
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Forums
Jeep Wrangler YJ
YJ General Discussion
Quick grind
Reply to thread
Message
<blockquote data-quote="jeepjoe43" data-source="post: 430194" data-attributes="member: 19255"><p>That will absolutely do it.</p><p>With your drive shaft angle the fix is SYE with a CV shaft.</p><p>I left the angle shims on my lift springs not realizing this conversion was needed.</p><p>Maybe could have taken them out, but probably would need to extend the shaft.</p><p>But after the horror of discovering the factory set-up, wasn't going waste my time with it.</p><p>(I only went up 2-1/2", so that may not even be an option for you)</p><p>I immediately lost the ability to more than 45 without it sounding like I was stuffing it in reverse.</p><p>Don't try to buy an off the shelf shaft, have one custom built, I got mine from Tom Woods Custom.</p><p>And they were actually less expensive than generic length off the shelf.</p><p>They have a lot useful info on their site.</p><p><a href="https://4xshaft.com/?gclid=Cj0KCQjwraqHBhDsARIsAKuGZeGgRF-RH4fRUvhOlpUx0LjtddueaH5aBjU9hV-Z9IdF3Co98St6LEQaAmWmEALw_wcB" target="_blank">https://4xshaft.com/?gclid=Cj0KCQjwraqHBhDsARIsAKuGZeGgRF-RH4fRUvhOlpUx0LjtddueaH5aBjU9hV-Z9IdF3Co98St6LEQaAmWmEALw_wcB</a></p></blockquote><p></p>
[QUOTE="jeepjoe43, post: 430194, member: 19255"] That will absolutely do it. With your drive shaft angle the fix is SYE with a CV shaft. I left the angle shims on my lift springs not realizing this conversion was needed. Maybe could have taken them out, but probably would need to extend the shaft. But after the horror of discovering the factory set-up, wasn't going waste my time with it. (I only went up 2-1/2", so that may not even be an option for you) I immediately lost the ability to more than 45 without it sounding like I was stuffing it in reverse. Don't try to buy an off the shelf shaft, have one custom built, I got mine from Tom Woods Custom. And they were actually less expensive than generic length off the shelf. They have a lot useful info on their site. [URL]https://4xshaft.com/?gclid=Cj0KCQjwraqHBhDsARIsAKuGZeGgRF-RH4fRUvhOlpUx0LjtddueaH5aBjU9hV-Z9IdF3Co98St6LEQaAmWmEALw_wcB[/URL] [/QUOTE]
Verification
Post reply
Forums
Jeep Wrangler YJ
YJ General Discussion
Quick grind
Top
Bottom