Forums
New posts
Search forums
Image search
Shop
Amazon Store
T-Shirts
Stickers
Members
Current visitors
Supporting Member Upgrade
Sponsors
About
Log in
Register
Search
Search titles only
By:
Search titles only
By:
New posts
Search forums
Image search
Search
Search titles only
By:
Search titles only
By:
Menu
Install the app
Install
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Forums
Jeep Wrangler YJ
YJ General Discussion
Question about replacing rear main seal
Reply to thread
Message
<blockquote data-quote="skyzero" data-source="post: 438713" data-attributes="member: 18773"><p>I'm in the middle of replacing the rear main seal and have a question. I replaced both halves, making sure they were seated well. After torqueing down the bearing cap to 80ft-lbs, I noticed the edges of the seal kind of look pinched up a bit? Is this correct or did I mess up along the way?</p><p></p><p>Some pictures of what I mean:</p><p>[MEDIA=imgur]a/JmpfYpy[/MEDIA]</p><p></p><p>Thanks for any help!</p></blockquote><p></p>
[QUOTE="skyzero, post: 438713, member: 18773"] I'm in the middle of replacing the rear main seal and have a question. I replaced both halves, making sure they were seated well. After torqueing down the bearing cap to 80ft-lbs, I noticed the edges of the seal kind of look pinched up a bit? Is this correct or did I mess up along the way? Some pictures of what I mean: [MEDIA=imgur]a/JmpfYpy[/MEDIA] Thanks for any help! [/QUOTE]
Verification
Post reply
Forums
Jeep Wrangler YJ
YJ General Discussion
Question about replacing rear main seal
Top
Bottom