Forums
New posts
Search forums
Image search
Shop
Amazon Store
T-Shirts
Stickers
Members
Current visitors
Supporting Member Upgrade
Sponsors
About
Log in
Register
Search
Search titles only
By:
Search titles only
By:
New posts
Search forums
Image search
Search
Search titles only
By:
Search titles only
By:
Menu
Install the app
Install
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Forums
Jeep Wrangler YJ
YJ General Discussion
Problem getting Crown body mount to fit
Reply to thread
Message
<blockquote data-quote="TRevs" data-source="post: 440054" data-attributes="member: 20654"><p>I used sandpaper and a little grindstone to clean up the hole, and measured with calipers. The hole diameter is about 1.5-2mm less than the bushing. </p><p></p><p>Is the center ring supposed to be there? It seems lightly tacked to the rest of the crossmember. If that comes out the the outer hole would be about 38mm which I’m afraid would let the bushing move around. </p><p></p><p>[ATTACH=full]122110[/ATTACH]</p><p></p><p></p><p>[ATTACH=full]122111[/ATTACH]</p><p></p><p>[ATTACH=full]122112[/ATTACH]</p></blockquote><p></p>
[QUOTE="TRevs, post: 440054, member: 20654"] I used sandpaper and a little grindstone to clean up the hole, and measured with calipers. The hole diameter is about 1.5-2mm less than the bushing. Is the center ring supposed to be there? It seems lightly tacked to the rest of the crossmember. If that comes out the the outer hole would be about 38mm which I’m afraid would let the bushing move around. [ATTACH type="full"]122110[/ATTACH] [ATTACH type="full"]122111[/ATTACH] [ATTACH type="full"]122112[/ATTACH] [/QUOTE]
Verification
Post reply
Forums
Jeep Wrangler YJ
YJ General Discussion
Problem getting Crown body mount to fit
Top
Bottom