Forums
New posts
Search forums
Image search
Shop
Amazon Store
T-Shirts
Stickers
Members
Current visitors
Supporting Member Upgrade
Sponsors
About
Log in
Register
Search
Search titles only
By:
Search titles only
By:
New posts
Search forums
Image search
Search
Search titles only
By:
Search titles only
By:
Menu
Install the app
Install
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Forums
Jeep Wrangler YJ
YJ General Discussion
Problem getting Crown body mount to fit
Reply to thread
Message
<blockquote data-quote="Pman" data-source="post: 440049" data-attributes="member: 21034"><p>I'm a little confused..you say the 2 mounts in front of the fuel tank but the pics show the rear crossmember and the side? </p><p></p><p>If we are indeed talking about the crossmember in FRONT of the fuel tank..there is 2 pieces of metal that form the area where the rubber mount fits into. They are not always perfectly aligned. I would suspect there is a build up of crud between the pieces and that won't let the bushing slide down. </p><p></p><p>Can you get your hand in there with a wire brush or sand paper and clean the hole up?</p></blockquote><p></p>
[QUOTE="Pman, post: 440049, member: 21034"] I'm a little confused..you say the 2 mounts in front of the fuel tank but the pics show the rear crossmember and the side? If we are indeed talking about the crossmember in FRONT of the fuel tank..there is 2 pieces of metal that form the area where the rubber mount fits into. They are not always perfectly aligned. I would suspect there is a build up of crud between the pieces and that won't let the bushing slide down. Can you get your hand in there with a wire brush or sand paper and clean the hole up? [/QUOTE]
Verification
Post reply
Forums
Jeep Wrangler YJ
YJ General Discussion
Problem getting Crown body mount to fit
Top
Bottom